Results 11 to 12 of 12
Thread: Fly By Wire
-
02-11-2007, 04:48 PM #11
Roberto............you are invited to come over and do some test flying. Mainly to test the drink table I guess !!
Just updating the cnc motor and spindle, as the one I have been using is showing a little too much out of round, so should have that rectified by the week-end. Will then cut out the remaing panels for the pedestal, which should be fairly fast, then to get the software up to date, hopefully.
Cheers................Brian W.
-
02-17-2007, 01:12 PM #12
I have to get My Australian Visa I have vacations again in October was planning to heading to Ianīs Cameron Place and I think Iīll head to yours too Brian if there is no problem a lot OF BEER I guess LOL!!!
THANKS FOR THE INVITATION!
Roberto
Similar Threads
-
how to wire it up?
By CessnaGuy in forum General Builder Questions All Aircraft TypesReplies: 15Last Post: 03-17-2010, 02:33 PM -
What is PM Fly By Wire (FBW)
By autocadplease in forum PM General Q & AReplies: 10Last Post: 07-26-2009, 08:03 PM -
What wire to use?
By autocadplease in forum I/O Interfacing Hardware and SoftwareReplies: 5Last Post: 01-22-2009, 05:37 PM -
Saving wire on an LED 64
By Paul G in forum Computer Hardware SetupReplies: 0Last Post: 08-15-2008, 04:49 AM
Search Pretty Girls from your town for night
JeeHell FMGS on a remote Computer