Need testers for 737 systems simulator software

[Lukewheatley]

Hi I dnt know I'd this has been mentioned but when u press attend the call Annunciator flashes but when pressed again its dose not go off???

[737NUT]

How do you get the baro setting to inches instead of MB?

[ANDYSMITH]

How do you get the baro setting to inches instead of MB?

Top right knob on the EFIS, push in and turn left. Pushing in without turning sets "STD".

Or, right click on the software MCP and select "EFIS" then use that knob.

Andy Smith


edit: Marty has this on his "to do" list to add this setting in the instructor station for a default to "inches".

[737NUT]

Thanks!

Looking forward to next update.

Top right knob on the EFIS, push in and turn left. Pushing in without turning sets "STD".

Or, right click on the software MCP and select "EFIS" then use that knob.

Andy Smith


edit: Marty has this on his "to do" list to add this setting in the instructor station for a default to "inches".

[metamarty]

Hi I dnt know I'd this has been mentioned but when u press attend the call Annunciator flashes but when pressed again its dose not go off???

It is a signal used for training sessions. It will sound an alarm in the instructor station. The flashing is turned off on the instructor station under the "failures" tab.

[yoss]

Marty, i wonder if the Cpflight expansion board MCPEX1, witch is configurable unlike their MIP board will be recognized and configured in Prosim as IO

Thanks

[metamarty]

Marty, i wonder if the Cpflight expansion board MCPEX1, witch is configurable unlike their MIP board will be recognized and configured in Prosim as IO

Thanks

Currently, there is no support since I dont have the specifications yet. The configuration util from CPFlight is only usefull if you run the CPFlight software in FS, which you should not do if the MCP is run from within Prosim. Prosim controls the CPFlight MCP from ProsimMCP.

[737NUT]

How do you get the Vertical Display to show in the ND? Latest release is working well! Thanks!
Rob

[metamarty]

How do you get the Vertical Display to show in the ND? Latest release is working well! Thanks!
Rob

The vertical display is not done yet, primarily because it needs to show terrain. This will be researched when I start doing the terrain function.

[markusr]

Hello Marty,

is it in the actual version possible to control the CDU via FSUIPC ?
I want to start testing with prosim in my cockpit.
Thanks,
Markus