Results 1 to 2 of 2
Thread: Displaying Heading Info on LED
-
05-03-2006, 07:51 AM #1
- Join Date
- May 2006
- Posts
- 3
Displaying Heading Info on LED
I am trying to conceptually put together a MCP panel using Phidgets.
Using FS2Phidget, I can scale the value in FS, but it only works up until 179 degrees and then from 180 on it goes negative.
Being new to Phidgets, when I go to display the 0-359 value on my MCP, how am I going to convert the -180-179 to 0-360 (I know that is not technically correct scale-wise, but hopefully you know what I mean . . . ). Is there a scale in the LED module and does the LED module work with FS2Phidget?
Thanks for any insight you can provide.
David
-
05-06-2006, 09:25 AM #2alandyerGuest
David,
I have built a solution into version 4.0 to
normalize angle values into the 0-360 range.
If you would like a pre-release version of 4.0 to evaluate send email to
alan@coconutair.
Regards,
Alan.
Similar Threads
-
FS9 not displaying correct resolution in Hardware Settings
By Michael Carter in forum Computer Hardware SetupReplies: 5Last Post: 02-01-2009, 09:03 PM -
767 gc ATT not displaying
By 767300 in forum PM General Q & AReplies: 2Last Post: 06-16-2008, 11:45 AM -
TCAS for online flying not displaying
By mgrant in forum PM and FSReplies: 34Last Post: 10-05-2007, 12:05 PM -
Displaying ISIS standby Display with Engine Instruments
By mattford1 in forum PM General Q & AReplies: 6Last Post: 06-26-2007, 07:46 PM -
Flight Plans in CDU not displaying
By paul douglas in forum PM General Q & AReplies: 2Last Post: 01-28-2006, 10:04 PM
Pretty Girls from your city for night
Generic Analog Gauges