Results 1 to 2 of 2
Thread: Analog Pots for 737 Yoke
-
10-04-2005, 08:53 AM #1Jeff C.Guest
Analog Pots for 737 Yoke
Hello,
I am a new member to the group, and could really use some guidance. Question: can I use the 100A analog pots out of my old CH Products yoke with the appropriate Phidgets board for the new column yoke I am buiding?
Thank You All,
Sincerely
Jeff C.
-
10-09-2005, 08:47 AM #2alandyerGuest
Jeff,
Not familiar with CH Products or your specific project requirements.
If your question is "Do pots vary voltage ?" then the answer is:
Yes. You can connect any resistance that will alter Phidget's analog port voltage between 0 and 5V.
Details that are specific to your project. e.g whether to use rotary or slider pots, range of shaft travel, linearity, noise, etc you will to need to figure out your specific application.
Regards,
Alan.
Similar Threads
-
Yoke pots to BU0836x ports
By nax228 in forum I/O Interfacing and HardwareReplies: 3Last Post: 01-07-2011, 12:58 PM -
th2go analog and w7
By Mr. Midnight in forum Computer Hardware SetupReplies: 7Last Post: 08-06-2010, 10:12 AM -
PM analog flap gauge off from FS.
By Randy Eskow in forum PM General Q & AReplies: 0Last Post: 02-05-2006, 11:16 AM -
new 8/8/8 with new style 3 pin analog connectors
By landwerlen in forum FS2Phidget UsersReplies: 4Last Post: 11-28-2004, 12:19 AM -
analog input question
By David Lee in forum Phidgets & Cockpit Simulator BuilderReplies: 4Last Post: 11-05-2004, 06:52 PM
Search Girls from your city for night
B_34 TOGA takeoff