Low values for N1 and N2, and thanks.

[RobertoR]

I'm driving four servos for twin turboprop engine N1 and N2 gauges, and I find that the FS values, as shown in the FS2phidgets window, are around 1500 when N1 and N2 are around 70%. I would espect some 10000, with a full scale value 16384.
The servos rotation angles are also low, accordingly.
Torque values, which I obtained after adding the offsets in the ini file, are regular.
Is there any explanation? Can I overcome the problem by setting lower full scale values in the ini file?
In the meanwhile, many thanks to Geoff and Alan for their support in the past posts, and a BIG thank to Alan, and anyone else who may have been involved in the software development, for the excellent FS2phidget package. It is essential, self explaining and it does everything that's needed. I would gladly contribute to the development expenses if there is a way to do it.

Roberto

[RobertoR]

I replaced 16384 with 3000 as a maximum value for N1 and N2 in the ini file, and it works
Roberto

[alandyer]

Thanks, Rob.

Updated my FSUIPC.ISI file.