Results 1 to 3 of 3
Thread: AML switches
-
01-11-2005, 06:24 PM #1
- Join Date
- Dec 2004
- Posts
- 8
AML switches
Question I am using momentary AML switches on my MCP and was wondering if its not possible to give this switch 2 commands so it can stay on in FS2004 when pushed and when pushed again turns off
Any help on this would be appreciatte it
regards,
Nihad
-
01-12-2005, 04:05 AM #2imported_MattOGuest
Depends on what software you are using. I e.g. use PM and the following code works for me with momentary switches, such as the AML switch.
[FCU_SET_LOC]
offset=4F2
Length=4
FSType=Digital
OffValue=0
OnValue=28
Hope this answers your question.
Matt O.
-
01-12-2005, 07:33 AM #3
- Join Date
- Dec 2004
- Posts
- 8
Hi Matt,
I am trying to figure out all this so sorry about that.
With the code u just added in your reply do u use that in the fs2phidget? and yes I own the PM software too.
If not if u could please tell me where this code needs to be added.
regards,
Nihad
Similar Threads
-
EEC Switches AFT OVH
By Tony in forum Cockpit Parts and Motion PlatformsReplies: 1Last Post: 08-19-2009, 12:26 PM -
Switches?
By Drewsta in forum I/O Interfacing Hardware and SoftwareReplies: 5Last Post: 07-21-2008, 10:06 AM -
switches and more switches...
By Jackpilot in forum Cockpit Parts and Motion PlatformsReplies: 0Last Post: 01-10-2008, 06:18 PM -
switches?
By Brenton Hill in forum I/O Interfacing Hardware and SoftwareReplies: 8Last Post: 12-20-2007, 08:16 PM -
Toggle switches to momentary switches?
By Patrik in forum Where to Start Building a Home CockpitReplies: 5Last Post: 10-23-2007, 09:58 AM
Pretty Girls from your city for night
Generic Analog Gauges