Results 1 to 2 of 2

Thread: Phidget rotary

  1. 12-14-2004, 01:40 PM #1
    wchambers
    wchambers is offline
    10+ Posting Member
    Join Date
    Oct 2004
    Posts
    17
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Phidget rotary

    I have been reading some threads about the Phidget rotary encoders that are apparently plug and play. Do they inferface with the FS2Phidget software or another program? Just wondering as these would seem to solve lots of issues for my overhead panel. Also, is there a limit as to how many could be attached to a computer say using a USB hub? Thanks in advance.

    Will Chambers
    Reply With Quote Reply With Quote
  2. 12-14-2004, 03:37 PM #2
    phidgets
    Guest
    Hello, the encoders have the USB already on them and plug right in, you will need the phidgets.msi installed and FS2Phidget to use them with MSFS. There is some calibrating and set up involved.

    To get a feel for it take a look at the FS2Phidget manual.
    http://www.phidgetsusa.com/fs/fs2phi...uick_start.asp


    A computer can have 255 USB components attached to it so you are fine there.

    Matt
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Turning a Rotary encoder with a pushbutton into a dual rotary encoder
    By snizbatch in forum I/O Interfacing Hardware and Software
    Replies: 2
    Last Post: 05-11-2009, 02:57 AM
  2. Building a 45 Deg rotary from a standard 30 deg rotary ?
    By shafian in forum I/O Interfacing Hardware and Software
    Replies: 1
    Last Post: 12-11-2008, 06:57 PM
  3. LED 64 Phidget
    By wchambers in forum Phidgets & Cockpit Simulator Builder
    Replies: 1
    Last Post: 11-09-2004, 09:51 PM
  4. 8/8/8 phidget help
    By imported_737nut in forum Phidgets & Cockpit Simulator Builder
    Replies: 4
    Last Post: 11-03-2004, 06:00 PM
  5. Problem with Phidget USB rotary
    By David Lee in forum FS2Phidget Users
    Replies: 2
    Last Post: 10-18-2004, 03:27 PM