YD indication on PFD problem

[dcutugno]

Hi, i have YD indication on PFD, and even if i turn on the YD in PMsystems the indication stay orange, will it have to change on green or disappear?

I might be wrong, if so correct me.

[Bob Reed]

What happens if you turn on or off the YD in FS?

[dcutugno]

I have tryed the Normal YD switch on the pmsystem panel and the switch on bottom right that said fsyawdamper, what are the keys in fs to turn it on or off?

[Bob Reed]

I do not know the keys to turn the FS YD on and off. I am not in a position to look right now. I do know that PM does not model YD. So turning the switch on in PMSystems really does not do anything. In FS, go to options. assignments and look for the keys for YD.

[dcutugno]

Ok Thomas, but how about my original post? YD (remains orange in PFD)

[Bob Reed]

Hi Thomas... Well I stand partially corrected.. And i am not afraid to say I am wrong! PM does not model YD but DOES run FS YD. So is your pressure over 1300psi?

[dcutugno]

I have set it to On 'cause i want the indication status of the YD, i verified the HYD Pressure and it is 2800psi, but the YD remains Amber regardless i switch On or Off in Pmsystems

[Bob Reed]

Ahhh Another piece of information that might be involved! Never thought of that.

[dcutugno]

I use PMDG737 model.

[aluver]

I use PMDG too. With Yaw damper line replacement ( yaw_damper_gain = 1.0000 ), it works now !