Results 1 to 3 of 3
  1. 01-27-2013, 01:52 PM #1
    Jeff869565
    Jeff869565 is offline
    10+ Posting Member
    Join Date
    Jan 2012
    Location
    Amsterdam, NY
    Posts
    11
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    FlyEngravity backlight upgrade kit

    I recieved the backlight upgrade panels for my desktip kit...however,, there is no information. From what I can tell they are 12 volt, but I don't know what amp I need. Also...can they be wired together in a chain? Thanks for any help.

    Jeffrey
    Reply With Quote Reply With Quote
  2. 01-27-2013, 06:35 PM #2
    dnoize
    dnoize is offline
    500+ This must be a daytime job
    Join Date
    Nov 2005
    Location
    rotterdam, the Netherlands, Europe
    Posts
    803
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: FlyEngravity backlight upgrade kit

    12V, 2A should be sufficient (in fact we power the entire ICS Plug and Play MIP (so interface + Panels) with only 1.2 A).

    you can connect the panels in parallel to one power source, allthough i would recommend 2 seperate channels for the captains and first officers side allowing independent brightness control.
    Reply With Quote Reply With Quote
  3. 01-27-2013, 07:42 PM #3
    Jeff869565
    Jeff869565 is offline
    10+ Posting Member
    Join Date
    Jan 2012
    Location
    Amsterdam, NY
    Posts
    11
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: FlyEngravity backlight upgrade kit

    Thank you.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »