Results 1 to 2 of 2
  1. 10-16-2012, 08:55 AM #1
    gregh
    gregh is offline
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    May 2008
    Location
    Perth
    Posts
    8
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Run time error 9

    I am getting run time error 9 with a High current stepper motor on the USB port. The 8/8/8 by itself is ok. I am running the latest version but it also crashes with the provios version of fs2phidgets. The error and crash also happens when I have a Bipolar stepper motor connected.
    Ver 4.3.66 Windows 7 64 bit.
    Any one with any ideas?


    Greg
    Reply With Quote Reply With Quote
  2. 10-19-2012, 03:33 PM #2
    CocnutAir
    CocnutAir is offline
    builder
    Join Date
    Jan 2007
    Location
    Texas
    Posts
    582
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Run time error 9

    Greg,
    I take it that stepper works ok with Phidget Control Panel.
    Unfortunately, I do not have HC version of stepper to check it out.
    Does Fs2Phidget list the motor on the main screen.
    send me your Fs2Phidget log file to alan@coconutair.com
    Log is located in same folder as fs2phidget and is named Fs2Phidget.log
    Regards,
    Alan
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »