Results 1 to 3 of 3

Thread: Servo motors

  1. 11-05-2011, 04:11 PM #1
    johnnyg
    johnnyg is offline
    75+ Posting Member
    Join Date
    Dec 2010
    Location
    Usa
    Posts
    102
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Servo motors

    Does anyone know how to get a servo motor to work to control an elevator using phidgets card 2010 - PhidgetAdvancedServo Kit 4-Motor and fsx 10.or a project file to control a attitude indicator using two motors.
    Reply With Quote Reply With Quote
  2. 11-05-2011, 05:15 PM #2
    AK Mongo
    AK Mongo is offline
    500+ This must be a daytime job


    Join Date
    Oct 2009
    Location
    Juneau, AK
    Posts
    547
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Servo motors

    Are you looking at an elevator control, or trim indicator?

    You could check out the instruction manual for simkits attitude indicator on their site to see how they build one.

    Reid
    http://juneaucessnasim.blogspot.com
    N58243 (virtual)- Low and Slow...
    Reply With Quote Reply With Quote
  3. 11-06-2011, 10:56 AM #3
    johnnyg
    johnnyg is offline
    75+ Posting Member
    Join Date
    Dec 2010
    Location
    Usa
    Posts
    102
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Servo motors

    It's not how it's built that I can do. It's how it's programmed to work for a cessna 172.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »