Results 1 to 1 of 1
Thread: Saving wire on an LED 64
-
08-15-2008, 04:49 AM #1
- Join Date
- Mar 2007
- Location
- Vancouver
- Posts
- 192
Saving wire on an LED 64
Is there any way of reducing the amount of wire in connecting LEDs to an LED64 phidget board? It seems that each LED has it's own ground. So my question is whether several LEDs could share the same ground by connecting one to ground on the phidget board, and then bridging the other leds to the led that has a ground connection. This is the way it would be done with switches, but wondering if it can be done with the LED 64
VANCOUVER
Jet fighter / single pilot sim, plus thinking of a 777 as a secondary sim.
Similar Threads
-
Saving State of pmSystems on exit
By Hans Krohn in forum PMSystemsReplies: 13Last Post: 04-04-2011, 07:50 PM -
Saving mastercard inputs?
By aVaTar in forum OpenCockpits General DiscussionReplies: 0Last Post: 01-30-2011, 10:07 AM -
saving multimonitor setup
By Drewsta in forum General Builder Questions All Aircraft TypesReplies: 12Last Post: 06-27-2008, 04:46 PM -
Saving routes in cdu
By Patrick Smith in forum PM General Q & AReplies: 1Last Post: 06-27-2007, 12:29 AM -
Problem saving flightplans to CDU
By Greg Theulings in forum PM General Q & AReplies: 1Last Post: 01-24-2006, 10:12 AM
It was great listening to this, remembering what a wonderful person and great influence Ian was to...
MyCockpit Podcast "Tips And...