Results 1 to 3 of 3
  1. #1
    150+ Forum Groupie Suggy's Avatar
    Join Date
    Oct 2005
    Location
    Hull, England
    Posts
    151
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    'Clicking' Sound after AP disconnect

    Hi!

    When the Autopilot is disconnected and after the aural warning there is a clicking sound (3 clicks?). What is that sound?

    Thanks,

    Darren Sugden

  2. #2
    MyCockpit Support Staff dodiano's Avatar
    Join Date
    Oct 2005
    Location
    El Salvador
    Posts
    929
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Hi Darren,

    If I recall correctly the 3 clicks it´s when you have an ILS capability Downgrade, Conditions required for CAT3/CAT2 are no longer fulfilled so you here the 3 clicks, sometimes when you take over manually you´ll here it cause it reverts from CAT 3 to Cat I on teh FMA!

    Regards,

    Roberto

  3. #3
    150+ Forum Groupie Suggy's Avatar
    Join Date
    Oct 2005
    Location
    Hull, England
    Posts
    151
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Thanks Roberto.

    Darren

Similar Threads

  1. AutoHotKey tip for button clicking
    By peterthisted in forum I/O Interfacing Hardware and Software
    Replies: 4
    Last Post: 03-25-2010, 10:28 PM
  2. AutoPilot Disconnect
    By ADW in forum OpenCockpits General Discussion
    Replies: 2
    Last Post: 01-11-2010, 08:17 AM
  3. X-Plane Thunder Sound addon sound pack
    By Padraig in forum General X-Plane (Laminar Research)
    Replies: 4
    Last Post: 12-12-2009, 07:24 AM
  4. AT Disconnect in FCU
    By brianwilliamson in forum PM Airbus FCU
    Replies: 0
    Last Post: 08-24-2008, 01:16 AM
  5. A/T disconnect offsets
    By NicD in forum I/O Interfacing Hardware and Software
    Replies: 4
    Last Post: 08-02-2007, 07:37 PM