input reverse

[aviaparts]

I wonder if it is possible via FS2phidget software to reverse a state of a switch.
For example, a switch is wired the wrong way, it is off when it should be on. So a phisical solution would be to turn the switch (as the lever has to be in the upright position for the on state).
It would be easier if it would be possible to do this via the software, I have been looking into it but can't seem to find it. Is it possible ?

Thanks

[aviaparts]

I should have googled sooner :

Inverting Component function


Builders may wish to swap or invert the function of Phidget Components either because:

- Component was wired wrong way around.

- Reverse functionality may be required.



Checking the invert check box will have the following affect (or is that, effect?) on these Phidgets:

- Digital input ON and OFF switch positions will be reversed.

- Digital output ON and OFF indications will be reversed.