Results 1 to 1 of 1
Thread: FS Communicator
-
03-03-2008, 11:07 AM #1
FS Communicator
Hi,
I finally spent some time tweaking and configuring (probably will spend some more) and registered FSCOMM, as I have reached a nice performance.
I do have a question regarding the Alpha-Protection mode. When approaching stall, FSCOMM triggers this protection, consisting in disconnecting AP, limiting pitch-up angle and setting autothrust into TOGA mode. So far so good.
My problem is that after some moments with TOGA thrust, the system sets the thrust to IDLE, with catastrophic results, of course, even though the levers are in CLB position.
Any idea of why this happens? What may I have incorrectly set?
Thanks!Luis Gordo
Instructor StationTM - www.iStationGordo.com
Similar Threads
-
FS communicator airbus FBW users
By pdpo in forum Cockpit Software: MiscellaneousReplies: 5Last Post: 07-28-2008, 04:41 AM -
FS Communicator development
By luisgordo in forum Cockpit Software: MiscellaneousReplies: 0Last Post: 02-06-2008, 04:40 PM -
FS Communicator users - led output help needed
By Suggy in forum I/O Interfacing Hardware and SoftwareReplies: 0Last Post: 09-23-2007, 08:56 AM -
FS Communicator?
By Bob Reed in forum I/O Interfacing Hardware and SoftwareReplies: 0Last Post: 12-19-2006, 04:25 PM
Can any won help, my opencockpits mcp has been working fine. Untill recently, when i ran flight...
kenfly issue