Results 1 to 2 of 2
-
12-09-2005, 06:41 PM #1
Preferred/recommended PM program startup sequence?
Hi,
Is there a preferred/recommended program startup sequence?
I especially wonder about pmSystems, whether I should start this direct after MSFS?
What I do now is:
PC1 starts
MSFS with WideFSserver, pmMCP, pmSounds. (also CPflight MCP+EFIS connected)
PC2 starts
WideFS client
pmGC in F6 extended mode showing PFD/ND/standby/upperEICAS
PC3 starts
WideFS client
pmCDU
PC4 starts
WideFS client
pmSystems (also Phidgets boards connected)
on PC3 I then load the FSflightplan through the RTE pagesKester Meijer
http://www.mycockpit.nl - to see my cockpit construction
Certified De-Ice Supervisor EHAM
-
12-09-2005, 07:30 PM #2
- Join Date
- Oct 2005
- Location
- Holley, New York U.S.A.
- Posts
- 1,776
Well after the sim is up and running I would fire up and get the CDU up and going. That is where the net directories are all set. Then however you see fit...
Similar Threads
-
Where to find real beginners-info for SIOC programming, preferred in dutch, otherwise in english
By bstikkel in forum OpenCockpits General DiscussionReplies: 5Last Post: 09-22-2010, 11:02 AM -
recommended reading
By Jackpilot in forum General Builder Questions All Aircraft TypesReplies: 1Last Post: 10-17-2008, 09:59 AM -
Correct engine startup sequence
By bapilot54 in forum General Builder Questions All Aircraft TypesReplies: 0Last Post: 09-17-2008, 03:51 PM -
Boeing start sequence
By PaulEMB in forum PMSystemsReplies: 4Last Post: 05-11-2007, 03:07 PM -
engine start sequence
By Pete in forum FS2Phidget UsersReplies: 1Last Post: 03-28-2005, 08:27 AM
It was great listening to this, remembering what a wonderful person and great influence Ian was to...
MyCockpit Podcast "Tips And...