Can I use this type of Rotary Encoder for FSBus

[RobiD]

I have about 50 of these that I bought some time ago. No data sheet but this is what they look like.

http://www.bourns.com/data/global/pdfs/PEC12.pdf

Can they be used with FSBus.

David

[sgaert]

hi,
they look good, but try it.

Stefan

[RobiD]

hi,
they look good, but try it.

Stefan

Hi Stefan,

I have tried them but I am not getting what should happen as in the instructions.

Tried all things with them but I just get 1's and 0's. No -1's

I have followed the tutorial in the manual 100% but I must be missing something.

I have put all the gauges back into the sim and I am going to fly for a while and then do some more coding.

Appreciate any help you can offer with these encoders though.

Thanks
David

[sgaert]

Tried all things with them but I just get 1's and 0's. No -1's

Did you mark them ase a rotary Input??

[RobiD]

Did you mark them ase a rotary Input??

I followed Dirks instructions. I used flat cable, pin 1 to first wire, pin 2 second wire, pin 3 to third wire. (then I tried all variations of this ie: wire 1 to pin 2 etc)

Plugged it into port 20 or position 20 as it has to start on a even number, and in FSAdmin, Set key 20 to Phase A type rotary (infact, I tried all the types type b, BCD, even Greyhill even tried setting 20 and then 21 to type A, type B etc) they all did exactly the same thing ie:

20 1
20 0
21 0
21 1

[sgaert]

Did you set the jumper for configuration?

[RobiD]

Did you set the jumper for configuration?

Ok, there's something new. What jumper. Do I need to set a jumper to configure the switch type in FSAdmin?

[sgaert]

IO-Docu on Page 18.
"Set J16 jumper on the IO board. Change to Set CID tab and set the
desired controller ID."

[RobiD]

IO-Docu on Page 18.
"Set J16 jumper on the IO board. Change to Set CID tab and set the
desired controller ID."

The contoller CID of the DIO board is 27 and has been set for months, but are you saying that I have to set J16 in order to configure the switch types?

[sgaert]

Yes. Every change on a FSBUS board (Display not) need to set the config jumper.