A320 FMGS B41

[Pim van Vrijaldenhoven]

Hallo Fritz,

TOPCAT communicates with P3D via WideFS. It sends the fuel and weights to the aircraft. Then you load these in FMGS in the INIT 2 page.

Best regards,

--pim

[Fritz]

Thanks for the reply Pim. Then I’m afraid TOPCAT would not be a workaround for this problem.
It seems that Teamviewer disrupt the fuel load from P3D to FMGS. That’s why I ask, if TOPCAT communicates direct to FMGS.

[Pim van Vrijaldenhoven]

Hallo Fritz,

I don't understand. I use TeamViewer to start P3D + FMGS from my office PC. On my office PC, I also have PFPX + TOPCAT + WideFS. From there I send the weight and fuel to P3D. This always has worked, also with my previous B738 sim using ProSim737. I actually see the plane move a little bit when the weight and fuel get loaded.

Best regards,

--pim

[OmniAtlas]

Hallo Fritz,

TOPCAT communicates with P3D via WideFS. It sends the fuel and weights to the aircraft. Then you load these in FMGS in the INIT 2 page.

Best regards,

--pim

i run topcat on the same computer as P3D

[Fritz]

Hi Pim,

I guess it depends on the system configuration. On my main computer are only P3D and the necessary modules of FMGS ( such as FMGS Server ) installed . All other modules as OVHRD , MCDU_CPT , MCDU_FO etc. are distributed to three additional computers .
With TeamViewer I start all applications on the different computers. This is necessary because I cannot fully see the monitors in the cockpit. I start FMGS first on the main computer and then the other. I began from Cold and Dark, turn the batteries on and then try to start the APU. The APU would not start because the tanks are empty. I have to shut down and restart FMGS on the main computer. Then the tanks are refilled.
As I understand JeeHell, this problem is caused by TeamViewer.


Thanks OmniAtlas

[jeehell]

Hi,

I do not recommend using teamviewer.
There is a known bug (I cannot find why yet) that causes simconnect crash with FSX / P3D.
Prefer using VNC on your local network.

JL

[OmniAtlas]

Is there an alternate (one click executive) solution to run applications on a remote computer

I found this link to remotely shutdown the Windows computer --

http://www.howtogeek.com/109655/how-...rt-windows-pcs

I would like to start the programs, and the computer without using a remote login viewer program such as VNC, teamviewer.

[Airmichel]

Hello JL,
I use Topcat over network and VNC, and have the same problems with fuel load like OmniAtlas. The most fuel is load in the right tanks.

Regards

Micha

[OmniAtlas]

Hello JL,
I use Topcat over network and VNC, and have the same problems with fuel load like OmniAtlas. The most fuel is load in the right tanks.

Regards

Micha

I use topcalt on the localhost as P3D, I will retest again, never had this issue before.

[Fritz]

Is there an alternate (one click executive) solution to run applications on a remote computer

I found this link to remotely shutdown the Windows computer --

http://www.howtogeek.com/109655/how-...rt-windows-pcs

I would like to start the programs, and the computer without using a remote login viewer program such as VNC, teamviewer.

I've also been thinking about that. How about creating a autostart.bat (Batch File) which
starts the FMGS modules when the computer starts .