Results 1 to 2 of 2
  1. #1
    Forum Moderator
    Join Date
    Nov 2008
    Location
    Essex / EGMC
    Posts
    2,104
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Generic Airbus Window Panel

    Hi All,

    Using the many dimensions, photos and drawings of the Airbus window, I have combined all the curves, angles, slopes and actual measurements to find the 'average' or 'common' within them all. I have come up with this very basic profile, although very simple, it comprises of 2 parts. The profile panel and window board panel. The idea of this very simple design is to make a template of the profile panel and cut from 12mm MDF. Then, add a 2" thick styrofoam and cut. Then by using the window board panel cutout, cut this from styrofoam and sandwich the 2 pieces together. With the window complete, you can angle the window, and then carve in any angles, you can then sand it, coat it, sand again, and then spray and lacquer.

    I think this can be quite effective!

    Attached Images Attached Images
    Building An Airbus In My Garage!

  2. #2
    New Member
    Join Date
    Mar 2011
    Location
    italy
    Posts
    4
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Generic Airbus Window Panel

    Great job!

    Giulio