Results 1 to 2 of 2
  1. #1
    300+ Forum Addict manhattan's Avatar
    Join Date
    Nov 2007
    Location
    Plymouth UK
    Posts
    347
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    ATC MAPPED TO BUTTONS?

    Trying to contact Gywn (Westozy).

    Some time ago, you had four red buttons on your yoke which were mapped to ATC. I can't figure out how to use ATC with these buttons?
    Even if I use the keyboard keys direct, I cannot hit the relevant numbers shown on the ATC box? Once I enter the frequency, and one of the numbers, I cannot go any further with any other numbers! If you see this message I would be very grateful if you could tell me how it's done?

    Does anybody know of a module or software that can be used to operate ATC remotely with proper usable number selections?

    Here's hoping.

    TONY Plymouth UK

  2. #2
    150+ Forum Groupie twisted8's Avatar
    Join Date
    Jun 2009
    Location
    California
    Posts
    243
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: ATC MAPPED TO BUTTONS?

    Maybe you are using the numeric pad? numeric pad doesn't work for me to select ATc options, but regular numbers (the ones bellow the f1-f10 keys) works fine for me. I use the opencockpits CDU which uses a keyboard emulator and pressing the numbers on the CDU also work for me.