Results 1 to 2 of 2
  1. #1
    New Member
    Join Date
    May 2014
    Location
    USA
    Posts
    1
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Bell 206 builder

    Hi.

    Just joined the Mycockpit family. Have had a 172 sim pit for about five years now and looking to convert it to a Bell 206 using Dodosim. Any leads to other working or completing a similar project would be great. I have seen some amazing work over the last few months. Most notably Jess at computerrepairs.ca

    Have flown the Dodosim a bit with a home hacked Saitek extreme stick and a flipped over Saitek throttle quadrant. Has been fine up until now but the resolution and controls were so sloppy, the already tough job of flying a helicopter was made even more unpredictable.
    Attached Images Attached Images

  2. #2
    MyCockpit Support Staff


    Westozy's Avatar
    Join Date
    Nov 2005
    Location
    Perth, Western Australia
    Posts
    1,488
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Bell 206 builder

    Aerosim Solutions (Brisbane branch) has prototype Bell 206 flight controls under construction!!

    Cheers Gwyn

    737NG using Prosim737, Immersive Calibration Pro, Aerosim Solutions motorized TQ & cockpit hardware, CP Flight MCP & FDS SYS1X, SYS2X & SYS4X, FDS PRO FMCs, AFDS units & Glarewings, Matrix Orbital ELEC display, Pokeys Landing & Cruise alt display, Buttkicker Gamers, 3 x BenqMW811ST projectors with a Matrox Th2Go
    http://www.aerosimsolutions.com.au
    Supporter of MyCockpit.org, please join me in donating!!!