Results 1 to 2 of 2
  1. #1
    150+ Forum Groupie SSO's Avatar
    Join Date
    Jun 2008
    Location
    Copenhagen, Denmark
    Posts
    234
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Question Adding a static VC with the cockpit outline

    Hi all,

    Is there anyone who can direct me to how I can add a static VC with the cockpit outline to the Project Airbus JeeHell A320 in P3Dv2.2?
    I see tutorials for FSX but there is no default A321 in P3D

    Thanks
    Cheers Stephen
    P3Dv4 Prof, FMGS A320, 1080p OH for ext. & 1080p 24" for int., TM Warthog, VATSIM (vPilot)

  2. #2
    2000+ Poster - Never Leaves the Sim


    OmniAtlas's Avatar
    Join Date
    Jun 2012
    Location
    Sydney, Australia
    Posts
    2,051
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Adding a static VC with the cockpit outline

    I am attempting to integrate interactive 2D panels with FMGS....no such luck so far but will keep you updated if I come up with anything.

    I have been able to use the Project Airbus 380 pedestal 2d panels with FMGS...however the panels (such as the throttle) are not controllable -- FMGS overrides any settings.

    The aim is to create 2d panels for the brake panel, and the pedestal so we can use a fully functioning touch screen computer based trainer.

    I understand emulation of hardware with software is possible (for example, I am using a software based throttle levers to interface with FMGS); jeehell has done it himself with the overhead 2d panel (which also contains the autobrake and engine start switches)....the question is understanding how to program a 2d panel to access these FSUIPC offsets.