Results 1 to 2 of 2
  1. #1
    150+ Forum Groupie SSO's Avatar
    Join Date
    Jun 2008
    Location
    Copenhagen, Denmark
    Posts
    234
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Running Jeehell Networked

    Hi,

    I am still in the initiasl testing phase migrating from all on FS pc to half on Laptop.
    While doing this I have a number of panel items on both.
    It seems OK for some, but not all are synced properly, and hence my questions
    FCU, MCDU, lower ECAM, PFD, ND seem synced.
    However OH, and Upper ECAM are not synced.
    Upper ECAM on Laptop for example does not show Thrust lever positions when moved (on FS PC)
    OH on laptop does not sync w OH on FS PC, from the initial pressing of BAT1.

    1 - Thoughtsabout the above?
    2 - Should the OH (w logic) run on both PC's?
    3 - Can all (Incl. OH) be offloaded to non FS PC?
    4 - Can the system tolerate doubling of all Panelparts?

    Thanks
    Cheers Stephen
    P3Dv4 Prof, FMGS A320, 1080p OH for ext. & 1080p 24" for int., TM Warthog, VATSIM (vPilot)

  2. #2
    2000+ Poster - Never Leaves the Sim
    Join Date
    Mar 2008
    Location
    France,Nice
    Posts
    2,427
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Running Jeehell Networked

    Hi,

    2 - No
    3 - it can
    4 - No

    I guess it should fix a lot of your issues once you run only one instance of each...

    Regards,
    JL