Results 1 to 5 of 5
Thread: Yoke Calibration Issue
-
03-10-2013, 12:29 PM #1
- Join Date
- Mar 2013
- Location
- Germany
- Posts
- 6
Yoke Calibration Issue
Hello, just had a quick question has anyone had any problems with PFC yokes or any yoke for that matter with calibration. I am using the Cirrus Beech usb yoke so the install should be a generic usb run through. What happens is the aileron axis jumps around anywhere from half to full deflection after rotating about half way to the right. Thank you and have a good one.
-
03-11-2013, 11:59 AM #2
- Join Date
- May 2012
- Location
- Great white north
- Posts
- 23
Re: Yoke Calibration Issue
Only thing I can think of with the way usb yokes calibrate is that perhaps you're not managing to get the run through soon enough after the yoke is connected. if you have FSUIPC then I think you may be able to smooth out the jumps if you can't fix them.
-
03-14-2013, 01:30 PM #3
- Join Date
- Mar 2013
- Location
- Germany
- Posts
- 6
Re: Yoke Calibration Issue
Steve, thank you for the advice I tried going through quicker but no luck. Thinking its hardware on this one I will give updates when it gets straightened out.
-
03-15-2013, 03:56 PM #4
Re: Yoke Calibration Issue
It may be electrical noise, try to seperate the yoke cabel, so it does not run parallel with other cables.
Sincerely,
Claus
-
04-03-2013, 02:43 PM #5
- Join Date
- Mar 2013
- Location
- Germany
- Posts
- 6
Re: Yoke Calibration Issue
I meant to post back sooner sorry about that. Turned out being the potentiometer little remove and replace now everything is good to go. Thank you everyone for the help hopefully this will help out someone down the road with the same issue.
Candid connections: Platform for casual relationships Live Women Prime Сasual Dating
Super Сasual Dating - Genuine...