Results 1 to 5 of 5
  1. #1
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Mar 2013
    Location
    Germany
    Posts
    6
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Yoke Calibration Issue

    Hello, just had a quick question has anyone had any problems with PFC yokes or any yoke for that matter with calibration. I am using the Cirrus Beech usb yoke so the install should be a generic usb run through. What happens is the aileron axis jumps around anywhere from half to full deflection after rotating about half way to the right. Thank you and have a good one.

  2. #2
    25+ Posting Member
    Join Date
    May 2012
    Location
    Great white north
    Posts
    32
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Yoke Calibration Issue

    Only thing I can think of with the way usb yokes calibrate is that perhaps you're not managing to get the run through soon enough after the yoke is connected. if you have FSUIPC then I think you may be able to smooth out the jumps if you can't fix them.

  3. #3
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Mar 2013
    Location
    Germany
    Posts
    6
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Yoke Calibration Issue

    Steve, thank you for the advice I tried going through quicker but no luck. Thinking its hardware on this one I will give updates when it gets straightened out.

  4. #4
    150+ Forum Groupie verticallimit's Avatar
    Join Date
    Apr 2009
    Location
    Denmark, Sinding
    Posts
    230
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Yoke Calibration Issue

    It may be electrical noise, try to seperate the yoke cabel, so it does not run parallel with other cables.
    Sincerely,

    Claus


  5. #5
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Mar 2013
    Location
    Germany
    Posts
    6
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Yoke Calibration Issue

    I meant to post back sooner sorry about that. Turned out being the potentiometer little remove and replace now everything is good to go. Thank you everyone for the help hopefully this will help out someone down the road with the same issue.