Thread: Feedback & “close loop” sys.
11-13-2009, 09:33 AM #1
- Join Date
- Oct 2009
Feedback & “close loop” sys.
3DOF – hydraulic ready! Electronic ready! need just some connection advice!
I need understand principle of “feedback” & “close loop” connection, if I want motion base move both option: manual & automatic, how correct make connection for correct way closing loop?
- If motion base works automatic mode, loop closing from proportional valve driver (from cylinder position sensor to ->coil PWM modulator) correct?
- But how “close loop” if base motion under manual control? (E.g. MFS …NFS...etc) need write some option from software driver? Or?
By Barrykensett in forum General Microsoft Flight Simulator 10 (FSX)Replies: 0Last Post: 12-17-2010, 04:34 PM
By riche543 in forum Pilots Lounge - Let your Hair downReplies: 1Last Post: 07-28-2010, 11:07 AM
By Clive in forum My Cockpit UpdateReplies: 4Last Post: 07-12-2010, 01:13 PM
By Joe Cygan in forum Pilots Lounge - Let your Hair downReplies: 8Last Post: 10-29-2009, 11:01 AM
By Randy Eskow in forum PM General Q & AReplies: 1Last Post: 04-13-2006, 10:11 AM