Thread: managed descend problem
05-18-2009, 09:57 AM #1
- Join Date
- Nov 2005
- Helsinki - Finland
managed descend problem
Everything works now fine except descend. I have newest updates for my
A320 setup. Thrust is working fine with its thrust gates. TO/Climb/Cruise are
ok, althought TOC captures a bit late. In TOD plane dives normally but later
I descends only 1000f/min and I cannot reach programmed MCDU altitudes.
I'm above those points and I need to pull to OP DES mode.
Have anyone experienced this?
In FCU.ini there is ALT ACQ FACTOR and it says 5, but should it be 2.7 as a default?
If I change it to 2.7 next time it goes back to 5?
By manhattan in forum General Builder Questions All Aircraft TypesReplies: 9Last Post: 04-11-2011, 03:54 AM
By Boeing 747 Flyer in forum General Builder Questions All Aircraft TypesReplies: 9Last Post: 05-26-2010, 01:24 PM
By cfg061 in forum PM Boeing GCReplies: 2Last Post: 01-12-2009, 11:03 AM
By super80 in forum PM Boeing GCReplies: 9Last Post: 09-14-2008, 11:03 AM
By JWS in forum PM General Q & AReplies: 0Last Post: 03-08-2008, 04:38 AM