Results 1 to 4 of 4
Thread: FSBUS Com PCB 5V Power Supply
-
11-16-2008, 05:54 AM #1
FSBUS Com PCB 5V Power Supply
Does any body know if i can hook up a usb cable to the board instead of a power supply use only the Gnd and 5V power off of it? Because that would be so much easier for me to do...
-
11-16-2008, 06:47 AM #2
- Join Date
- Sep 2007
- Location
- Finland
- Posts
- 8
Hi,
I have taken +5V from computers powersupply (inside computer) there are 4 pin powercable same type as you use older hard drive.
There are 2 pin in the middle of 4 are BLACK as ground, RED +5V and YELLOW +12V.
I have used that red and black for FSBUS NG com board. Use electronic multimeter to measure those before you connect. MAKE SURE that you use that +5V RED.
Otherwise you will see some SMOKE.....
I dont know but i think that from USB you cant get enough current.... maybe i´m wrong.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes388TH_A thanked for this post
-
11-16-2008, 07:02 AM #3
USB probably does not have enough current for your board. Take the power from the power supply.
God's in command, I'm just the Pilot.
http://www.geocities.com/andytulenko/
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes388TH_A thanked for this post
-
11-16-2008, 12:10 PM #4
Alright thanks i didnt even think about the computer power supply. i guess i could use a old power supply and have it running on the side.
Similar Threads
-
PC power supply to power Phidgets LED 64
By drum4no1 in forum General Builder Questions All Aircraft TypesReplies: 1Last Post: 07-05-2010, 03:21 PM -
12V power supply
By Jackpilot in forum General Builder Questions All Aircraft TypesReplies: 4Last Post: 01-24-2009, 03:45 AM -
PC power Supply
By BlackWidow in forum Computer Hardware SetupReplies: 7Last Post: 11-25-2007, 11:50 PM -
Power Supply
By Tim in forum Cockpit Parts and Motion PlatformsReplies: 1Last Post: 05-28-2007, 08:13 AM
Candid connections: Platform for casual relationships Live Women Prime Đ¡asual Dating
Super Đ¡asual Dating - Genuine...