Results 1 to 3 of 3
  1. #1
    Our new friend needs to reach 10 posts to get to the next flight level indyana1's Avatar
    Join Date
    Mar 2007
    Location
    Melbourne
    Posts
    8
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    CPflight MIP & FDS AN1

    Hi,

    Just wondering if anyone here is using CPflight's MIP 737 board and FDS AN1 Annunciators?

    I've followed all the instructions regarding wiring but when tested through CPflight's test software it is very sporadic. I seem to get the red LED's working but I can't get the Green or Amber LED's to work as they should.

    I have tested all the LED's and they are all working OK.

    CPflight thinks it might be FDS PCB for the LED's, I just don't know.

    If anyone has any suggestions or has a similar setup that can help that would be very much appreciated.

    Regards,

    Mick CC

  2. #2
    150+ Forum Groupie Melnato's Avatar
    Join Date
    Jun 2007
    Location
    Melbourne, Australia
    Posts
    206
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Mate,

    Check that you haven't soldered the amber/green LED's upside down...I did two like that.

    The PCB is just an easy means to connect wiring loom to the LED's...that's all...not much can go wrong.

    Nat

  3. #3
    Our new friend needs to reach 10 posts to get to the next flight level indyana1's Avatar
    Join Date
    Mar 2007
    Location
    Melbourne
    Posts
    8
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Thanks for the help Nat, these were all pre-made by FDS so should all be correct you would think.

    Regards,

    Mick

Similar Threads

  1. CPFlight RS 232 to USB
    By mascot in forum Computer Hardware Setup
    Replies: 3
    Last Post: 11-20-2009, 01:55 PM
  2. CPFlight Do It Again
    By ian@737ng.co.uk in forum Cockpit Parts and Motion Platforms
    Replies: 2
    Last Post: 08-26-2008, 08:14 PM
  3. Thanks to PM & CPFlight
    By JWS in forum PM General Q & A
    Replies: 4
    Last Post: 04-15-2008, 03:38 PM
  4. CPFlight MCP - Need help
    By SAS541 in forum I/O Interfacing Hardware and Software
    Replies: 0
    Last Post: 02-19-2008, 01:49 PM