Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Fly By Wire

  1. 02-11-2007, 04:48 PM #11
    brianwilliamson
    brianwilliamson is offline
    300+ Forum Addict
    Builder Of The Month / Point Value: 100 Builder Of The Month / Point Value: 100
    Total Awards: 2
    Total Points: 200



    brianwilliamson's Avatar
    Join Date
    Oct 2005
    Location
    Gold Coast-AUSTRALIA
    Posts
    455
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Roberto............you are invited to come over and do some test flying. Mainly to test the drink table I guess !!
    Just updating the cnc motor and spindle, as the one I have been using is showing a little too much out of round, so should have that rectified by the week-end. Will then cut out the remaing panels for the pedestal, which should be fairly fast, then to get the software up to date, hopefully.
    Cheers................Brian W.
    Reply With Quote Reply With Quote
  2. 02-17-2007, 01:12 PM #12
    dodiano
    dodiano is offline
    MyCockpit Support Staff dodiano's Avatar
    Join Date
    Oct 2005
    Location
    El Salvador
    Posts
    930
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Airbus

    I have to get My Australian Visa I have vacations again in October was planning to heading to Ian´s Cameron Place and I think I´ll head to yours too Brian if there is no problem a lot OF BEER I guess LOL!!!

    THANKS FOR THE INVITATION!

    Roberto
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »

Similar Threads

  1. how to wire it up?
    By CessnaGuy in forum General Builder Questions All Aircraft Types
    Replies: 15
    Last Post: 03-17-2010, 02:33 PM
  2. What is PM Fly By Wire (FBW)
    By autocadplease in forum PM General Q & A
    Replies: 10
    Last Post: 07-26-2009, 08:03 PM
  3. What wire to use?
    By autocadplease in forum I/O Interfacing Hardware and Software
    Replies: 5
    Last Post: 01-22-2009, 05:37 PM
  4. Saving wire on an LED 64
    By Paul G in forum Computer Hardware Setup
    Replies: 0
    Last Post: 08-15-2008, 04:49 AM