Results 1 to 2 of 2
  1. #1
    New Member
    Join Date
    May 2006
    Posts
    3
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Displaying Heading Info on LED

    I am trying to conceptually put together a MCP panel using Phidgets.

    Using FS2Phidget, I can scale the value in FS, but it only works up until 179 degrees and then from 180 on it goes negative.

    Being new to Phidgets, when I go to display the 0-359 value on my MCP, how am I going to convert the -180-179 to 0-360 (I know that is not technically correct scale-wise, but hopefully you know what I mean . . . ). Is there a scale in the LED module and does the LED module work with FS2Phidget?

    Thanks for any insight you can provide.

    David

  2. #2
    alandyer
    Guest
    David,

    I have built a solution into version 4.0 to
    normalize angle values into the 0-360 range.

    If you would like a pre-release version of 4.0 to evaluate send email to
    alan@coconutair.

    Regards,
    Alan.

Similar Threads

  1. FS9 not displaying correct resolution in Hardware Settings
    By Michael Carter in forum Computer Hardware Setup
    Replies: 5
    Last Post: 02-01-2009, 09:03 PM
  2. 767 gc ATT not displaying
    By 767300 in forum PM General Q & A
    Replies: 2
    Last Post: 06-16-2008, 11:45 AM
  3. TCAS for online flying not displaying
    By mgrant in forum PM and FS
    Replies: 34
    Last Post: 10-05-2007, 12:05 PM
  4. Displaying ISIS standby Display with Engine Instruments
    By mattford1 in forum PM General Q & A
    Replies: 6
    Last Post: 06-26-2007, 07:46 PM
  5. Flight Plans in CDU not displaying
    By paul douglas in forum PM General Q & A
    Replies: 2
    Last Post: 01-28-2006, 10:04 PM