Results 1 to 2 of 2
  1. 04-15-2006, 11:56 PM #1
    hugso
    Guest

    G forces in fight sim

    I want to use a Phidget to control a servo (which controls the pressure in pneumatic pressure pads in my seat) so that the position of the servo (and hence the pressure pushing up from my seat) is proportional to the value of G overload in DeviceLink used in IL2 flight sim.

    This value is a plus or minus number and DeviceLink uses UDP protocol. Is there likely to be a way for me to do this?
    Reply With Quote Reply With Quote
  2. 04-26-2006, 07:51 AM #2
    alandyer
    Guest
    No support for Devicelink at this time.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Manipulating actuators for g-forces
    By grumman_gooser in forum Cockpit Parts and Motion Platforms
    Replies: 1
    Last Post: 08-17-2008, 02:42 AM
  2. Anyone using the Fight Illusion Interface Card
    By Kris Stow in forum I/O Interfacing Hardware and Software
    Replies: 6
    Last Post: 03-13-2008, 04:39 PM
  3. Calculation of g-forces in LOMAC
    By egoexpress in forum Cockpit Parts and Motion Platforms
    Replies: 3
    Last Post: 09-10-2007, 07:26 AM
  4. How to Autostart Fight in FSX?
    By brianwilliamson in forum General Builder Questions All Aircraft Types
    Replies: 6
    Last Post: 01-16-2007, 02:27 AM