Best way to connect LEDs to LED64?

[alandyer]

Million dollar question:
Did Rob just get lucky with his LED64 ?

For those wondering, I would go with advice from the designer of Phidgets.
(Prof. Fitchett).

[imported_Bill]

Hi.
This may seem a simplistic question to those who are ahead of me, but, being more enthusiastic for my project rather than skilled, can I ask how to mount the soldered LED's accurately behind the overhead?

Should I build a light frame of some kind to hold the LED's in position. Any other solution would be very welcome.

Best Regards,
Bill

[imported_Bill]

First, apologies for attempting to 'twist' the thread!
Second, please ignore my above request - brain was in disengaged mode, didn't realise 'my' lights were not on !

What I was attempting to talk about is a 737 overhead panel I got from an East European site.
Close examination of the reverse side revealed small (not at first obvious) indentations in which LED's are located.

So I'll now start marrying my Phidgets with it !

Regards,
Bill

[DCO]

OK, thanks guy's, I'll go for the single led option.
John, I am not sure wat kind of led you are referring to, would you have a typnumber or something ?

Marnix