Results 1 to 3 of 3

Thread: AML switches

  1. #1
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Dec 2004
    Posts
    8
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    AML switches

    Question I am using momentary AML switches on my MCP and was wondering if its not possible to give this switch 2 commands so it can stay on in FS2004 when pushed and when pushed again turns off
    Any help on this would be appreciatte it

    regards,

    Nihad

  2. #2
    imported_MattO
    Guest
    Depends on what software you are using. I e.g. use PM and the following code works for me with momentary switches, such as the AML switch.

    [FCU_SET_LOC]
    offset=4F2
    Length=4
    FSType=Digital
    OffValue=0
    OnValue=28

    Hope this answers your question.

    Matt O.

  3. #3
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Dec 2004
    Posts
    8
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Hi Matt,

    I am trying to figure out all this so sorry about that.
    With the code u just added in your reply do u use that in the fs2phidget? and yes I own the PM software too.
    If not if u could please tell me where this code needs to be added.

    regards,

    Nihad

Similar Threads

  1. EEC Switches AFT OVH
    By Tony in forum Cockpit Parts and Motion Platforms
    Replies: 1
    Last Post: 08-19-2009, 12:26 PM
  2. Switches?
    By Drewsta in forum I/O Interfacing Hardware and Software
    Replies: 5
    Last Post: 07-21-2008, 10:06 AM
  3. switches and more switches...
    By Jackpilot in forum Cockpit Parts and Motion Platforms
    Replies: 0
    Last Post: 01-10-2008, 06:18 PM
  4. switches?
    By Brenton Hill in forum I/O Interfacing Hardware and Software
    Replies: 8
    Last Post: 12-20-2007, 08:16 PM
  5. Toggle switches to momentary switches?
    By Patrik in forum Where to Start Building a Home Cockpit
    Replies: 5
    Last Post: 10-23-2007, 09:58 AM