Results 1 to 2 of 2
  1. #1
    10+ Posting Member
    Join Date
    Oct 2004
    Posts
    17
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Gear handle question

    I just received my 737 gear handle and wired it up the my 0/8/8 Phidget - the Phidget sees it and recognizes it but when I assign it the "gear handle" option (which is the only appropriate assignment I saw) and run it - the gear just move back to their original position - i.e. if they are down - they move up and then back down - any suggestions would be greatly appreciated. The gear handle assembly uses what appears to be a two way switch with a piece of metal exposed on the top that when contacted depresses a switch underneath. Thanks for you time.

    Will

  2. #2
    phidgets
    Guest
    Hi Will,


    You might want to repost this in the FS2Phidget forum to get Alan to reply.

    Matt

Similar Threads

  1. Question Regarding Landing Gear Control
    By Buddym in forum I/O Interfacing Hardware and Software
    Replies: 0
    Last Post: 04-18-2009, 08:16 PM
  2. Finally installed the gear handle...
    By Michael Carter in forum My Cockpit Update
    Replies: 13
    Last Post: 08-02-2007, 04:19 AM
  3. WTB: Landing gear handle
    By gokhotit in forum Phidgets & Cockpit Simulator Builder
    Replies: 0
    Last Post: 11-30-2004, 02:22 AM
  4. Gear Handle question
    By wchambers in forum FS2Phidget Users
    Replies: 5
    Last Post: 11-26-2004, 11:59 AM