Results 1 to 2 of 2
  1. #1
    Jeff C.
    Guest

    Analog Pots for 737 Yoke

    Hello,

    I am a new member to the group, and could really use some guidance. Question: can I use the 100A analog pots out of my old CH Products yoke with the appropriate Phidgets board for the new column yoke I am buiding?

    Thank You All,
    Sincerely
    Jeff C.

  2. #2
    alandyer
    Guest
    Jeff,

    Not familiar with CH Products or your specific project requirements.
    If your question is "Do pots vary voltage ?" then the answer is:

    Yes. You can connect any resistance that will alter Phidget's analog port voltage between 0 and 5V.

    Details that are specific to your project. e.g whether to use rotary or slider pots, range of shaft travel, linearity, noise, etc you will to need to figure out your specific application.

    Regards,
    Alan.

Similar Threads

  1. Yoke pots to BU0836x ports
    By nax228 in forum I/O Interfacing and Hardware
    Replies: 3
    Last Post: 01-07-2011, 12:58 PM
  2. th2go analog and w7
    By Mr. Midnight in forum Computer Hardware Setup
    Replies: 7
    Last Post: 08-06-2010, 10:12 AM
  3. PM analog flap gauge off from FS.
    By Randy Eskow in forum PM General Q & A
    Replies: 0
    Last Post: 02-05-2006, 11:16 AM
  4. new 8/8/8 with new style 3 pin analog connectors
    By landwerlen in forum FS2Phidget Users
    Replies: 4
    Last Post: 11-28-2004, 12:19 AM
  5. analog input question
    By David Lee in forum Phidgets & Cockpit Simulator Builder
    Replies: 4
    Last Post: 11-05-2004, 06:52 PM