Results 1 to 2 of 2
  1. #1
    JAMES WEBSTER
    Guest

    RE: Run away AT/MCP speed

    Hi guys,

    I am getting a similar problem. Using full magenta setup except PM systems.

    Flying 757200 with 757 FFG PM FILE for the 752. I set the trust limit on the
    init ref / thrust limit page. Capped at 95%N1. I have the correct Vspeeds
    set and retract flaps on sched. I have the AT engeged and follow the FD up
    on climb, but the airspeed fires up close to 290kts indicated. If I
    increase AoA to shed speed the thrust is increased to maintain this climb at 290.

    All the usual restrictions in place 250 below Fl100

    Tend to manually set thrust and on reaching Vref30 + 80 I engage the AT which
    holds this speed.

    Any Ideas or CDU settings I have missed?

    James


  2. #2
    Enrico Schiratti
    Guest

    Re: Run away AT/MCP speed

    > Flying 757200 with 757 FFG PM FILE for the 752. I set the trust limit on

    > the
    > init ref / thrust limit page. Capped at 95%N1. I have the correct Vspeeds
    > set and retract flaps on sched. I have the AT engeged and follow the FD

    up
    > on climb, but the airspeed fires up close to 290kts indicated. If I
    > increase AoA to shed speed the thrust is increased to maintain this climb


    > at 290.
    >
    > All the usual restrictions in place 250 below Fl100
    >
    > Tend to manually set thrust and on reaching Vref30 + 80 I engage the AT
    > which
    > holds this speed.
    >
    > Any Ideas or CDU settings I have missed?


    What rate of climb does the aircraft have when it does this? Is it roughly
    6000 Ft/min? Then you might have to derate the thrust for the climb.

    Ciao

    Enrico


Similar Threads

  1. Speed up fs9
    By Jake 747 400 in forum General Builder Questions All Aircraft Types
    Replies: 13
    Last Post: 09-19-2009, 02:47 AM
  2. Taxi speed
    By AchillesP in forum Cockpit Outside Visualization
    Replies: 0
    Last Post: 05-26-2008, 08:45 AM
  3. AT not holding speed ??
    By Mario Görs in forum PM and FS
    Replies: 3
    Last Post: 12-12-2007, 06:38 AM
  4. RE: Run away AT/MCP speed
    By Randy Eskow in forum PM General Q & A
    Replies: 0
    Last Post: 01-30-2006, 01:25 PM
  5. Run away AT/MCP speed
    By Randy Eskow in forum PM General Q & A
    Replies: 2
    Last Post: 01-29-2006, 11:05 PM