Results 1 to 2 of 2
  1. #1
    25+ Posting Member
    Join Date
    Jul 2012
    Location
    United Kingdom
    Posts
    45
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Problem: Engine and thrust lever disagree.

    Hi,

    Out of nowhere JL is now misbehaving; When I start the aircraft engines the engine thrust runs immediately up to N1~60%. The thrust levers are correctly commanding the donuts however the engine thrust does not respond in any FWD position. If the lever is placed into REV then the engine thrust returns to idle.

    The engine thrust responds correctly to FS keyboard controls (F1 - F4), however.

    Thrust levers are fully calibrated. and FMGS is correctly receiving and reading the thrust lever inputs (as indicated by the donuts) but it is not commanding engine thrust.

    I'm running B47.4.1 with Skalarki Hardware in P3DV4.

    I'm also getting a Windows socket error from HARDWARECONNECT however this is on a remote PC. The thrust lever hardware is connected directly to the main P3D and FMGS server PC.

    JL do you have a solution? Has anyone else seen this?

    Thanks

  2. #2
    150+ Forum Groupie
    Join Date
    Nov 2015
    Location
    Krefeld, GER
    Posts
    243
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Problem: Engine and thrust lever disagree.

    deselect Hardwareconnect in the starter.cfg on the remote PC, if your hardware is connected to the FMGS server pc.