A320 FMGS B47

[jeehell]

The interface should work. If the skalarki controls do not work, then first thing is to check with Marcin, as usual with hardware issues.

[Fritz]

Hi to all,

I have insert <<allowAFLOORinhibit=yes>> to x:\A320FMGS\FMGS Server\PERF\PA320\Aircraft.ini.
Deactivated <<Act as pushbutton>> and assigned only ATHR TAKEOVER for Action on state for Levers 1 and 2.
No assigment for Action on state:Off according to the skalarki JL_FMGS Profil.
I still cannot activate Auto thrust.

Does the problem still occur with someone or has it solved in the meantime? A feedback would be wonderful.

Best regards

[pete_fuss]

Hi to all,

this morning i have a problem with the updater!
on every pc in my homecockpit the updater is coming up, when i download the version i can read from version 47.0. i install it with admin rights, i start the starter.exe and the updater comes up again to updat to version 47.0!
Anyone the same problem or arework for me?

Regards Peter

[cmdr114b]

Yes, I can confirm this. Update software message continues even after the update has been made.
John

[pete_fuss]

Hi John,
i have fixed my problem!
You have to look for the date of the A320FMGS_B47_0.ex file it must be the 23.03.2017. in my case the downloader did`t override the older once! Run the exe file again and you will see if it update, after this the updater come once again to update the PFD. In the whats new.txt you see then the following:
A320 Software Solution Beta 47
------------------------------


23/03/2017
What's new in B47.0:
----------
-Corrected PFD display




22/03/2017
What's new in B47.0:
----------
-Corrected wrong version being displayed
-Reworked PFD/ND EIS2 layout a tiny bit (to take up all visible area).

Now in my system i`m on the actual point.

Regards Peter

[cmdr114b]

Ok, thanks I will try that.
John

[Beaufort]

The same to me and I can't adjust the gain

Adjusting gain works fine in my system.
I already mailed Marcin about the tilt prob.
@JL: By the way: THX a lot for this great upgrade! I just got Intercom working, that is really fantastic.

[startrail]

Hi,
I have the same issue.

cheers
Florian

Have the same issue too

[startrail]

Hi
Last update in the late afternoon, no particular problems except the FMA display which was incomplete, wider.
All is normal now after adding in aircraft.ini of C: \ A320FMGS \ FMGS Server \ PERF \ PA320
The following line: EISmodel = 2 to enable eis2

Since switching to B47 I no longer have the 'decel' display in green on the autobrake, it is active on the ECAM.
The display test is correct for all systems from "ann / l" in the test position on the overhead.
Am I the only one in this case ??

Thank you for your help
Best Regards
Ridha

I too don't have Decel on my autobrake module or on Ecam

[Ridha]

Hi
The autobrake Decel is ok on Max position, No Decel on Med position and Decel is ok on low position only at the last second when airplane stop ??
Ridha