Page 3 of 3 FirstFirst 123
Results 21 to 25 of 25
  1. #21
    500+ This must be a daytime job kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    698
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Level-D 767 G-Throttle Switch Interfacing

    Quote Originally Posted by Boeing 747 Flyer View Post
    Also, the stab trim cut out switches appear to be opposite to what they are set in my TQ; ie they're on when I have set them to off.
    That's the problem with these toggle commands. You have to synchronise your hardware with the Level-D panel: close FSX, set your hardware switches in the other position and start again.

    If I were you I would cut the wires and use a Mastercard, SIOC and lekseecon. Then you are really in control...

    My 2 cts...
    Nico

  2. #22
    500+ This must be a daytime job Boeing 747 Flyer's Avatar
    Join Date
    Nov 2009
    Location
    England
    Posts
    635
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Level-D 767 G-Throttle Switch Interfacing

    Hi Nico,

    I think I can live with that, I will start pretty much all of my flights with the stab trim switches set to norm anyway, and with the fuel cutoff switches set to cut. No problems!

    I take it I can't use a toggle function for Altn Stab trim control? We'll need some sort of repeater function.

  3. #23
    500+ This must be a daytime job kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    698
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Level-D 767 G-Throttle Switch Interfacing

    Quote Originally Posted by Boeing 747 Flyer View Post
    We'll need some sort of repeater function.
    In FSUIPC you will find "repeat while held" in the buttons tab...
    You only have to make a SIOC script that translates these button presses into increments and decrements within the range 0..140 expected by my lekseecon variable.

    Nico

  4. #24
    500+ This must be a daytime job Boeing 747 Flyer's Avatar
    Join Date
    Nov 2009
    Location
    England
    Posts
    635
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Level-D 767 G-Throttle Switch Interfacing

    Hi Nico,

    All is now done in terms of switches, thanks very much for your help!

  5. #25
    500+ This must be a daytime job kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    698
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Level-D 767 G-Throttle Switch Interfacing

    Quote Originally Posted by Boeing 747 Flyer View Post
    thanks very much for your help!
    You're welcome.
    Hope to see some pictures of your Throttle, and ofcourse what you think of it.

    Nico

Page 3 of 3 FirstFirst 123