Initial issues

[rictus]

Strangely, after restarting the software, the throttle detents are working fine, but the hardware throttle on my joystick is only moving THR1 all of a sudden and not both, despite being set to BOTH in the config... The lollipop marker on THR2 (right hand) thrust setting circle on the upper ECAM is in the gated position, i.e. CLB/MCT/FLX position...

[jeehell]

I'll look at that for next version...
You can confighure th same lever twice if needed (LVR1 and LVR 2).

JL

[rictus]

I wondered about that and did try before posting, but it didn't work.

When I load the config program I get a second window that offers 'complex' throttle setup. I've always used it because it seemed to be related to working with a single axis throttle and was the only way to get the 'both' option in the main config window... I noticed from the user manual that the throttle axis was directly specified in the lvr1 box rather than the 'title' of the complex throttle... Maybe I don't need to use it?

[jeehell]

Why do you use the complex axis setup? it is not related at all to configuring a single axis to both levers. It is for people who need to use either a switch or a second axis for the reverse part of the LVR course.

JL

[rictus]

Ah I thought so - Because it came up as the front most window and cannot be closed by itself without closing the main config window I thought it was necessary. I will have another fiddle!

I'm about to offload some of the displays to a networked computer - I assume I can configure the EXE to only open certain panels/displays on each PC, I will delve into the advanced setup instructions and see how I get on!

[rictus]

Edit - ignore... issue solved!