Results 1 to 8 of 8
Thread: 737 overhead panel
-
07-18-2012, 10:49 AM #1
- Join Date
- Jul 2012
- Location
- Near EDDF
- Posts
- 6
737 overhead panel
Hello Flightsimmers!
I am planning to build a Boeing 737 NG overhead panel and use it with the PMDG NGX and FSUIPC. I want to use the Arcaze USB-Interface with knobs, switches, etc. I am planning to use a wooden plate, glue a 1:1 overhead photo on it and mount the switches to the corresponding places.
1. Question: Has somebody made any experiences with the Arcaze USB-Interface?
2. Question: How can I get the corresponding lights and displays to work?
Regards
David
-
07-20-2012, 07:56 AM #2
- Join Date
- Nov 2010
- Location
- Copenhagen
- Posts
- 80
Re: 737 overhead panel
Hi David
I dont know this interface, but it seems to work like orthers. When you have connected a switch it will displayed as a joystick with many buttons, and FSUIPC will
see every switch. This way you can assign each.
For the lights you will need a output card. I have used OC's Output card it's quite easy to setup.
Regards
Claus
www.737sim.dk
-
07-20-2012, 09:05 AM #3
- Join Date
- Jul 2012
- Location
- Near EDDF
- Posts
- 6
Re: 737 overhead panel
Hello Claus!
Thanks for your answer! What software do you use for your output card? Do you use FSUIPC offsets?
David
-
07-20-2012, 09:46 AM #4
- Join Date
- Nov 2010
- Location
- Copenhagen
- Posts
- 80
Re: 737 overhead panel
Hi
I'm using SIOC which follows from OC. I'm reading the offsets from iFly, but if FSUIPC has offset for a specific light the you can use that. I'm sure that PMDG can deliver the same !
Under tutorials ón ny site you can see some exampels
Claus
-
07-20-2012, 10:53 AM #5
- Join Date
- Jul 2012
- Location
- Near EDDF
- Posts
- 6
Re: 737 overhead panel
Hi Claus!
Your Website and your project is exactly what I was looking for! Well done! One question, how can I find the tutorial you spoke about? When I klick the link on your website I am redirected to your Links page...
Regards
David
Edit: Thanks, I found the tutorials.
-
07-20-2012, 11:17 AM #6
- Join Date
- Nov 2010
- Location
- Copenhagen
- Posts
- 80
Re: 737 overhead panel
Good to hear, and yes it nees's some mainteance !
Try this
www.737sim.dk/page16.html
See the section belos the page
Claus
-
07-20-2012, 01:48 PM #7
- Join Date
- Jul 2012
- Location
- Near EDDF
- Posts
- 6
Re: 737 overhead panel
Hi Claus!
One question: Does your APU starter switch "jump back" ofter switching it to start like in the real one? And if yes, how did you do that?
David
-
07-20-2012, 03:01 PM #8
- Join Date
- Nov 2010
- Location
- Copenhagen
- Posts
- 80
Re: 737 overhead panel
Nope, it's a on-off-on, but you can get a on-on switch, but it works fine
Claus
Discover the ultimate in relaxed romance with the best casual dating platform! Free relationships,...
P3D V4 FMGS B47 Aircraft issue