Results 1 to 5 of 5
  1. #1
    150+ Forum Groupie
    Join Date
    Jan 2007
    Location
    Saskatchewan,Canada
    Posts
    229
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    assign led with no variable ?

    With the led64 ,Is it possible to assign an led to light up when a switch is activated but using no fsoutput ??
    For example,, a engine fire light or any other light that fs9 has no fsuipc offset for ?

    thanks

  2. #2
    builder
    Join Date
    Jan 2007
    Location
    Texas
    Posts
    582
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: assign led with no variable ?

    Yes. Create a circuit that has a digital input and a digital output. Assign digital output to an LED64.

  3. #3
    500+ This must be a daytime job



    Join Date
    Oct 2009
    Location
    Juneau, AK
    Posts
    553
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: assign led with no variable ?

    Does the input have to come through a phidget, or can it be assigned to a switch interfaced another way(ie buo836?). I would like to build a test switch for a warning panel, and this sounds interesting.
    http://juneaucessnasim.blogspot.com
    N58243 (virtual)- Low and Slow...

  4. #4
    builder
    Join Date
    Jan 2007
    Location
    Texas
    Posts
    582
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: assign led with no variable ?

    Googled buo836. This is joystick device based on Microchip's USB 40-pin PIC18F4550.
    I plan to add support for HID in future. Been playing around with PICs for my sim.

  5. #5
    150+ Forum Groupie
    Join Date
    Jan 2007
    Location
    Saskatchewan,Canada
    Posts
    229
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: assign led with no variable ?

    yes,, either a switch connected to a buo836x board or just a key press to activate the led ,, without using a fsoutput ?

    That would be very handy ,, especially for an instructor station .