Page 6 of 6 FirstFirst ... 23456
Results 51 to 53 of 53
  1. #51
    25+ Posting Member
    Join Date
    Mar 2013
    Location
    Finland
    Posts
    61
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Cessna 172 1:1 Panel Drawing

    i use acryl sheet about 2-3mm tichness and have lens sametime, only need cut encoder holes and paint frontside (tape cover first all gauges place) and then spay paint.
    bezell (if want use)can cut paper coffee cub edge. all has painted have wery real and good panell.
    but i have proplem how much reside gauges at monitor smalled can adding all gauges to 17" monitor(2 monitor at gauges)
    try test someday but no lot time
    and proplem,no have 1:1 size after reside
    just make ready flap position led indicator whit picaxe microcontroller, working fine. 5 led show were flaps have real panel near switch.(i use (on)-off(on) switch to panell. 6 point sw, right side connect to leo bodnar and use fs9 and left side connect to picaxe and show what you has bush, follow alltime switch were position flaps have.up-down.
    sorry i write lot
    same can use position indication led or servo and needle show position.
    next need move basic picaxe code to arduino but no time lot make all now.
    arduino have better can make many more same chip too, gears, switches etc more. link2fs must test more first.

  2. #52
    New Member
    Join Date
    Apr 2013
    Location
    tanzania
    Posts
    1
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Cessna 172 1:1 Panel Drawing

    Thanks for your good support. May god bless you and all the best to your project

  3. #53
    10+ Posting Member
    Join Date
    Nov 2014
    Location
    KPVD
    Posts
    11
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Cessna 172 1:1 Panel Drawing

    Anyone happen to know where I can find panel drawings for a C172 G1000? I looked on the simkits site, but they didn't have anything.
    PC: Intel Core i7-4790K 4.0 GHz | 16 GB DDR3 1600 | 1 TB SATA III + 120 GB SSD | NVIDIA Geforce GTX 970 4 GB

  4. Likes BrentonSpear liked this post
Page 6 of 6 FirstFirst ... 23456

Similar Threads

  1. Cessna Warning Panel Offsets
    By AK Mongo in forum General Aviation (GA) Builder Disccusion
    Replies: 15
    Last Post: 03-09-2016, 05:26 PM
  2. Cessna 650 cockpit, panel and pedestal
    By baali in forum General Aviation (GA) Builder Disccusion
    Replies: 4
    Last Post: 11-12-2011, 05:46 PM
  3. Drawing for 737 autobrake panel buttons
    By Wendy in forum CNC Discussion
    Replies: 9
    Last Post: 07-27-2011, 01:37 AM
  4. An Inexpensive Cessna Panel Look-a-like
    By steve34613 in forum Cockpit Parts and Motion Platforms
    Replies: 11
    Last Post: 07-19-2007, 11:39 PM