Results 1 to 4 of 4
  1. #1
    25+ Posting Member mascot's Avatar
    Join Date
    Oct 2009
    Location
    Switzerland
    Posts
    40
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    PC major failure

    Hi all, not such a short one this time Im afraid...

    There is the background: replaced old motherboard with Asus Maximus II Gene and added 4GB of Ram for a total of 8GB DDRII Ram. Setup Win 7 Pro 64 bit and installed all Hardware drivers etc again. My system ran perfectly with no overclocking or anything else for about 3 days. When I monitored it the temps where quite high but never at maximums and I ve never got any messages.

    So there comes the problem:

    Started my PC for a quick flight the fans go on for approx 3 secs and then turn of again. This repeats 2 times and then the fans start with min rpm and accelerate to probably max rpm in ca 2 mins. No screen no mouse no Bios no keyboard, just all black... What could that be? Burned something?

    Some hints maybe how to restore...

    Simon

  2. #2
    500+ This must be a daytime job


    Efe Cem Elci's Avatar
    Join Date
    Jan 2008
    Location
    Istanbul, Turkey, Turkey
    Posts
    509
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: PC major failure

    Are you getting any sequence of beeps from the pc speaker when you turn on the pc?

  3. Thanks mascot thanked for this post
  4. #3

    Re: PC major failure

    Hi I am Thomas.
    I hear only one bip at the time of my system boot.

  5. Thanks mascot thanked for this post
  6. #4
    25+ Posting Member mascot's Avatar
    Join Date
    Oct 2009
    Location
    Switzerland
    Posts
    40
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: PC major failure

    Hi Lads

    Thanks for your PMs and Hints.

    I had to reset my MB and start up using the old Graphics card. Set the Bios settings to default again clear CMOS and then install the newer GPU.

    Simpler as I tought...

    Greetz Simon

Similar Threads

  1. Fs2004 Failure Software
    By bapilot54 in forum General Builder Questions All Aircraft Types
    Replies: 4
    Last Post: 09-17-2008, 04:35 PM
  2. Speed tape failure in PFD
    By Jackpilot in forum PM Boeing GC
    Replies: 5
    Last Post: 12-18-2007, 08:34 PM
  3. Speed tape failure in PFD
    By Jackpilot in forum PM General Q & A
    Replies: 5
    Last Post: 12-18-2007, 08:34 PM
  4. FMC airway entry failure
    By dornier in forum PM General Q & A
    Replies: 0
    Last Post: 01-15-2007, 12:34 AM