Results 1 to 3 of 3
  1. 08-07-2009, 10:03 AM #1
    colaboy
    colaboy is offline
    25+ Posting Member
    Join Date
    Nov 2008
    Location
    Leeds, England
    Posts
    33
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Pots on a BU0836X

    Hi.
    I have been using my BU0836X just for rotaries and buttons.
    I now need to use the axis for my throttle quad.
    I'm sure that I remember reading somewhere that I can use 10K or 100K pots.
    Is this the case?
    If this is the case, if i'm not using the whole travel of the pot, would i be better using the 100K?
    My thinking behind this is that the board may see more change over the short distance. This may just be gibberish though as I don't know too much about these things.

    Any help would be greatly received.

    Thanks
    Paul
    Reply With Quote Reply With Quote
  2. 08-07-2009, 12:51 PM #2
    Buddym
    Buddym is offline
    300+ Forum Addict
    Tutorial Contributor / Point Value: 10
    Total Awards: 1
    Total Points: 10



    Join Date
    Jan 2009
    Location
    Tampa
    Posts
    487
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Pots on a BU0836X

    I am pretty sure I saw a post from Leo that said 10k or 100k either are fine. I use 10k myself.

    BuddyM
    Reply With Quote Reply With Quote
  3. 08-07-2009, 12:58 PM #3
    Trevor Hale
    Trevor Hale is offline
    2000+ Poster - Never Leaves the Sim Trevor Hale's Avatar
    Join Date
    Nov 2005
    Location
    Ontario, Canada
    Posts
    2,223
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Pots on a BU0836X

    Basically you would get smoother range of operation with a 100K pot, then you would a 10K.

    Not that anyone would notice, but the board assigns a value from say 1 to 65535 incrementally across the 10K

    or 1 to 65535 across the 100K range.

    If that helps..
    ________________________
    Trevor Hale
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Yoke pots to BU0836x ports
    By nax228 in forum I/O Interfacing and Hardware
    Replies: 3
    Last Post: 01-07-2011, 12:58 PM
  2. String Pots.....
    By Rodney in forum General Builder Questions All Aircraft Types
    Replies: 4
    Last Post: 03-05-2009, 05:28 PM
  3. pots
    By Radar in forum Cockpit Parts and Motion Platforms
    Replies: 1
    Last Post: 03-04-2008, 06:07 AM
  4. Pots 101
    By ak49er in forum General Builder Questions All Aircraft Types
    Replies: 10
    Last Post: 06-23-2007, 07:28 PM
  5. 747 Pots and 8/8/8
    By imported_farrokh747 in forum Phidgets & Cockpit Simulator Builder
    Replies: 2
    Last Post: 09-09-2005, 07:33 AM