Results 1 to 4 of 4
  1. #1
    2000+ Poster - Never Leaves the Sim Michael Carter's Avatar
    Join Date
    Oct 2006
    Location
    Southern Illinois, USA
    Posts
    2,887
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Nearing completion now...

    A test fit to the control stand.

    The flap mechanism and the slider pot and linkage is installed. Now I have to fit and install the stab trim cutout/normal switches and then finish the flap mechanism housing.

    I ordered the Beta Innovations Plasma MM2 to interface with. I was going to go with the FDS input modul, but the BI is much less expensive for the same capabilities.




  2. #2
    Executive Vice President, MyCockpit


    Matt Olieman's Avatar
    Join Date
    Oct 2005
    Location
    Ocala, FL USA
    Posts
    2,884
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Impressive, indeed

    Thanks for the photos.

  3. #3
    2000+ Poster - Never Leaves the Sim Michael Carter's Avatar
    Join Date
    Oct 2006
    Location
    Southern Illinois, USA
    Posts
    2,887
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Thank you Matt. It's been a long time coming.

  4. #4
    2000+ Poster - Never Leaves the Sim Michael Carter's Avatar
    Join Date
    Oct 2006
    Location
    Southern Illinois, USA
    Posts
    2,887
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Just waiting on the electronics now. The card shipped today, so it won't be long now.

    I still have a few placquards to mount.


Similar Threads

  1. 787 MIP Design Nears Completion
    By Lewis Simmons in forum My Cockpit Update
    Replies: 16
    Last Post: 06-13-2008, 06:28 AM