Results 1 to 2 of 2
  1. 10-29-2008, 05:49 AM #1
    dedalo70
    dedalo70 is offline
    New Member
    Join Date
    Oct 2008
    Location
    paris
    Posts
    4
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Sioc file for 737 pic by wilco/feelthere

    Hello,

    I'm Alex and I'm a new entry at Mycockpit forum. I'm trying to make a little cockpit in my room and I bought a MCP 737 NG v2 by Opencockpits. It works very well with fsx' planes but i can't use it with my favourite plane: 737 PIC by wilco, what a pity!!! I'm looking for a sioc file for this plane. I hope you can help me and i thank you for your kind attention.

    Best regards,

    Alex
    Reply With Quote Reply With Quote
  2. 11-02-2008, 09:02 AM #2
    OliT
    OliT is offline
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Aug 2008
    Location
    Leeds, UK
    Posts
    6
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Alex, I too am looking for a sioc file and have been for a while- I don't think there is one.

    Using the default settings the rotaries seem to work fine and I hoped to program sioc to emulate keystrokes which I would then program into the PIC definition pages. Frankly, I've not had time.

    If you have any luck please let me know!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. trigger .cmd file with SIOC - is this possible?
    By markusr in forum OpenCockpits General Discussion
    Replies: 4
    Last Post: 03-13-2011, 04:51 PM
  2. SIOC configuration file for PMSystems
    By MortenHa in forum PMSystems
    Replies: 2
    Last Post: 12-08-2008, 07:12 AM
  3. Configure MCP of Opencockpits with MCP of Project Magenta and file sioc. Help me.
    By paoloj in forum OpenCockpits General Discussion
    Replies: 3
    Last Post: 08-15-2008, 03:29 AM