Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. #11
    25+ Posting Member
    Join Date
    Aug 2008
    Location
    Netherlands
    Posts
    32
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    I've finished the outer case of the pedestal up to the point where I'm now ready to build and install the actual hardware. First to do is the throttle levers with their electronics.

    Important lesson learned while building the case: make sure your workpieces can't accidentally fall off the workbench. I had one sideboard upright leaning against the center brace I was going to fix it to, then turned to grab my cordless screwdriver and "thud!" there it was on the floor two corners damaged. I'll be able to repair it later, but boy I felt stupid.

    Pictures to follow.
    Ladies and gentlemen, we've just found an exception to the rule "what goes up, must come down": the landing gear.

  2. #12
    500+ This must be a daytime job


    Efe Cem Elci's Avatar
    Join Date
    Jan 2008
    Location
    Istanbul, Turkey, Turkey
    Posts
    509
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Looking forward to those pictures! Sounds like it is getting along well.

Page 2 of 2 FirstFirst 12

Similar Threads

  1. My Boeing 747-400 Pedestal Project
    By Boeing 747 Flyer in forum General Builder Questions All Aircraft Types
    Replies: 0
    Last Post: 01-23-2010, 05:37 PM
  2. RAL colour CDU pedestal/radio pedestal
    By curtis in forum General Builder Questions All Aircraft Types
    Replies: 2
    Last Post: 01-07-2009, 05:03 PM
  3. Starting Over
    By andarlite in forum My Cockpit Update
    Replies: 31
    Last Post: 12-15-2007, 01:58 PM
  4. Starting Again
    By Gsey in forum My Cockpit Update
    Replies: 1
    Last Post: 06-01-2007, 08:47 PM
  5. APU Not Starting
    By Gert van der Winden in forum FS2Phidget Users
    Replies: 16
    Last Post: 12-23-2004, 07:44 PM