Results 1 to 2 of 2

Thread: input reverse

  1. #1
    150+ Forum Groupie
    Join Date
    May 2006
    Location
    Belgium
    Posts
    150
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    input reverse

    I wonder if it is possible via FS2phidget software to reverse a state of a switch.
    For example, a switch is wired the wrong way, it is off when it should be on. So a phisical solution would be to turn the switch (as the lever has to be in the upright position for the on state).
    It would be easier if it would be possible to do this via the software, I have been looking into it but can't seem to find it. Is it possible ?

    Thanks
    [

  2. #2
    150+ Forum Groupie
    Join Date
    May 2006
    Location
    Belgium
    Posts
    150
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    I should have googled sooner :

    Inverting Component function


    Builders may wish to swap or invert the function of Phidget Components either because:

    - Component was wired wrong way around.

    - Reverse functionality may be required.



    Checking the invert check box will have the following affect (or is that, effect?) on these Phidgets:

    - Digital input ON and OFF switch positions will be reversed.

    - Digital output ON and OFF indications will be reversed.
    [

Similar Threads

  1. Reverse Thrusters on FSX
    By docmeister in forum General Microsoft Flight Simulator 10 (FSX)
    Replies: 5
    Last Post: 06-18-2009, 07:13 AM
  2. Setting reverse thrust
    By WJH308 in forum General Builder Questions All Aircraft Types
    Replies: 1
    Last Post: 10-03-2008, 05:31 AM
  3. Reverse flight plan
    By Jackpilot in forum PM General Q & A
    Replies: 5
    Last Post: 07-07-2007, 08:04 AM
  4. Can't get reverse anymore
    By Skydvdan in forum FS2Phidget Users
    Replies: 2
    Last Post: 12-13-2004, 11:53 PM